The heater matrix uses coolant to warm the air that enters the passenger cabin. Of course, this can influence the behavior of the complete coolant water circuit. This example illustrates how to add a heater matrix to a System.
To take care of an additional heater matrix in an existing KULI cooling system one has to add a radiator component to the KULI system. On the fluid side it is integrated to a normal coolant circuit using branch and confluence components. On the air side it is necessary to use two parallel branches to simulate separate air paths for the engine cooling part and for the HVAC part. The example is based on the basic example “Ex_Fluid.scs” from the KULI installation setup.Usable from release: KULI 8.0-1.04